Skip to main content
  1. Home
  2. Space
  3. News

Hubble Space Telescope restored and active following synchronization issue

By

After an error that occurred in late October forced it into safe mode, the Hubble Space Telescope is now back up and running at full strength.

Hubble suffered an issue with the communications between its computers and instruments on October 25, when several synchronization messages were lost. To prevent any damage to its instruments, the telescope automatically went into safe mode in which only the basic essential parts of the telescope functioned. That meant that it stopped collecting science data while engineers on the ground figured out what had gone wrong.

Recommended Videos

Throughout November, the Hubble team analyzed the issue and tested out the problems by turning on an older, unused instrument. This allowed them to perform a test without endangering the currently active instruments which Hubble still needs to use.

Related

As that test didn’t throw up any more errors, the team elected to turn on each of Hubble’s four currently active instruments one at a time. With no more missed synchronization messages, they turned on the final instrument — the Space Telescope Imaging Spectrograph — this week.

“NASA’s Hubble Space Telescope team recovered the Space Telescope Imaging Spectrograph on Monday, December 6, and is now operating with all four active instruments collecting science. The team has still not detected any further synchronization message issues since monitoring began November 1,” NASA wrote in an update.

NASA also explained that its Hubble team has a plan to prevent similar issues from happening again in the future, by allowing the instruments to continue operating even if a few synchronization messages are lost. To make this change, they will gradually make tweaks to Hubble’s software over the next few months, beginning in the next weeks.

“The team will continue work on developing and testing changes to instrument software that would allow them to conduct science operations even if they encounter several lost synchronization messages in the future,” the update said. “The first of these changes is scheduled to be installed on the Cosmic Origins Spectrograph in mid-December. The other instruments will receive similar updates in the coming months.”

This was the second time this year that Hubble has been in trouble, with an issue with its computer causing it to enter safe mode this summer as well.

Editors' Recommendations

Topics
Georgina Torbet
Georgina Torbet
Space Writer
Georgina is the Digital Trends space writer, covering human space exploration, planetary science, and cosmology. She…
Hubble image of the week shows an unusual jellyfish galaxy
The jellyfish galaxy JO206 trails across this image from the NASA/ESA Hubble Space Telescope, showcasing a colorful star-forming disk surrounded by a pale, luminous cloud of dust. A handful of foreground bright stars with crisscross diffraction spikes stands out against an inky black backdrop at the bottom of the image. JO206 lies over 700 million light-years from Earth in the constellation Aquarius.

This week's image from the Hubble Space Telescope shows an unusual type of galaxy named for its aquatic look-alike: a jellyfish.

The jellyfish galaxy JO206 is shown below in an image taken using Hubble's Wide Field Camera 3 instrument. Located 700 million light-years away, in the constellation of Aquarius, this image of the galaxy shows both the bright center of the galaxy and its long tendrils reaching out toward the bottom right. It is these tendrils that give jellyfish galaxies their names, and they are formed through a process called ram pressure stripping.

Read more
Hubble scientists create tool for erasing satellite trails from images
This image captures the streak of an Earth-orbiting artificial satellite crossing Hubble's field of view during an observation of "The Mice" interacting galaxies (NGC 4676). A typical satellite trail is very thin and will affect less than 0.5% of a single Hubble exposure. Though in this case the satellite overlaps a portion of the target galaxy, the observation quality is not affected. That's because multiple exposures are taken of the same target. And the satellite trail is not in other frames. Developers at the Space Telescope Science Institute in Baltimore, Maryland, have software that identifies the bad pixels from the satellite photobombing, the extent to which they affect the image, and then flags them. When flagged, scientists can recover the full field of view. Even as the number of satellites increases over the decade, these tools for cleaning the images will still be applicable.

With ever-increasing numbers of satellites in the sky, astronomers have repeatedly expressed worry over how these satellites could impact scientific research. Earlier this year, a study of Hubble Space Telescope observations showed how some images were being ruined by streaks of light coming from satellites -- and while only a small percentage of Hubble images were affected, the authors raised concerns that with the projected number of satellites set to explode in the next decade, the problem could become serious.

Now, astronomers at the Space Telescope Science Institute (STScI), which runs Hubble, have come up with a tool to deal with satellite streaks in Hubble images. "We developed a new tool to identify satellite trails that is an improvement over the previous satellite software because it is much more sensitive. So we think it will be better for identifying and removing satellite trails in Hubble images," said Dave Stark of STScI in a statement.

Read more
Astronomers discover three exoplanets in final data from Kepler Space Telescope
An artist's concept of the Kepler spacecraft.

The Kepler Space Telescope was retired in 2018 after a nine-year mission that saw it discover an incredible 2,600 confirmed exoplanets, kicking off the modern era of exoplanet research. But now there are three more exoplanets to add to the mission's total, even after the telescope has been dark for the last five years. Astronomers were recently able to use data from the very last observations of Kepler to discover three more planets.

Two of the three exoplanets have been confirmed -- K2-416 b and K2-417 b -- with a third planet, EPIC 246251988 b, remaining an exoplanet candidate. (To be upgraded from exoplanet candidate to confirmed exoplanet, an initial observation has to be verified through observations by two other telescopes.) The planets range from 2.6 times the size of Earth to 4 times the size of Earth, making them small in comparison to most discovered exoplanets.

Read more